Clarke CRS710V Інструкція з експлуатації та технічного обслуговування - Сторінка 11

Переглянути онлайн або завантажити pdf Інструкція з експлуатації та технічного обслуговування для Пила. Clarke CRS710V. Clarke CRS710V 17 сторінок.

CUTTING METAL

1. Install a metal cutting blade (supplied).

2. Coat the cutting surface with cutting oil to prevent the blade from

overheating.

• Follow general cutting procedure above.

WARNING: BEFORE PERFORMING ANY MAINTENANCE TASKS MAKE SURE

THAT THE MAINS PLUG HAS BEEN REMOVED FROM THE MAINS SUPPLY.

• After use, clean all dust and wood chippings from the reciprocating

saw.

• Clean all of the ventilation slots on the motor housing.

• Make sure that the shoe is free from dirt and grease.

• Keep the handle clean and free from oil and grease.

• Resin and glue on the blade causes poor cutting results. Clean the

blade after use.

• Refer to your CLARKE dealer if internal maintenance is required.

1. Remove the carbon brush caps

using a flat screwdriver.

2. Remove the carbon brushes and

replace with new ones.

• Replacement brushes are

available from the Clarke

spares department (part

number HTCRS710V58).

• Always replace the brushes in

pairs.

3. Replace the carbon brush caps.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]