Clarke CSS 300 Інструкція з експлуатації та технічного обслуговування - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та технічного обслуговування для Пила. Clarke CSS 300. Clarke CSS 300 11 сторінок. Woodworker 13" scroll saw
Друкувати сторінку
ELECTRICAL CONNECTIONS
Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an approved 13
amp BS 1363 plug, or a suitably fused isolator switch.
IMPORTANT: The wires in the mains lead are coloured in accordance with the following code:
As the colours of the flexible lead of this appliance may not correspond with the coloured markings
identifying terminals in your plug proceed as follows:
Connect GREEN & YELLOW coloured cord to plug terminal marked with a letter "E" or Earth
symbol "
"or coloured GREEN or GREEN & YELLOW.
Connect BROWN coloured cord to plug terminal marked with a letter "L" or coloured RED.
Connect BLUE coloured cord to plug terminal marked with a letter "N" or coloured BLACK.
If this appliance is fitted with a plug which is moulded onto the electric cable (i.e. non-rewirable)
please note:
1.
The plug must be thrown away if it is cut from the electric cable. There is a danger of electric
shock if it is subsequently inserted into a socket outlet.
2.
Never use the plug without the fuse cover fitted.
3.
Should you wish to replace a detachable fuse carrier, ensure that the correct replacement
is used (as indicated by marking or colour code).
4.
Replacement fuse covers can be obtained from your local dealer or most electrical stockists.
5.
The fuse in the plug must be replaced with one of the same rating (5 amps) and this
replacement must be ASTA approved to BS1362.
PRINCIPAL PARTS OF THE SCROLL SAW
Fig. 1
ASSEMBLY
Your Scroll Saw is fully assembled, except for the Blade Guard, and the Air tube. To attach these
components, proceed as follows:
Line up the slotted hole in the blade guard and that in the air tube bracket, with the hole in the
upper arm casing, and insert the bolt supplied. Note that the air tube bracket should lie between
the blade guard and the upper arm, as shown in fig. 1. Thread on the washer and nut and tighten
sufficiently so that the guard is firm but capable of movement. Do not over tighten.
WARNING! THIS APPLIANCE MUST BE EARTHED
Green & Yellow
-
Blue
-
Brown
-
5
Earth
Neutral
Live