Clarke CFI 1800 Інструкція з експлуатації та технічного обслуговування - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та технічного обслуговування для Обігрівач Clarke CFI 1800. Clarke CFI 1800 13 сторінок. Infrared wall heaters
Друкувати сторінку
OPERATION
1. Connect the mains cable to a suitable power socket.
2. Pull the string to repeatedly to
cycle through the following
settings:
CFI1800
• O = Off
• I = Heater elements on
CFI1800L
• O = Off
• I = Lamps only
• II = Heater elements on/lamps off
• III = Heating elements and lamps both on
CLEANING AND MAINTENANCE
WARNING: BEFORE CARRYING OUT ANY MAINTENANCE, ENSURE THE
HEATER IS SWITCHED OFF, DISCONNECTED FROM THE MAINS SUPPLY,
AND HAS BEEN GIVEN ADEQUATE TIME TO COOL DOWN.
PERIODICALLY
1. If there is any serious build up of dirt, wipe thoroughly with a damp cloth.
Take care that no moisture enters the heater.
2. Inspect the power cable for damage. Undue heat will cause the cable to
stiffen and crack, in which case it should be replaced.
3. Ensure heating elements are free of dust (use compressed air to clean if
possible. (Always wear a dust mask if performing this operation).
4. Refer to your Clarke dealer if the heater element or LED lamp need
replacing.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7