Clarke DEVIL 4100 Інструкція з експлуатації та технічного обслуговування - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та технічного обслуговування для Обігрівач Clarke DEVIL 4100. Clarke DEVIL 4100 15 сторінок. Fan heater
Друкувати сторінку
ELECTRICAL CONNECTIONS
Devil 4040
This model is provided with a 13 amp BS 1363 plug, fitted with a 13amp fuse and MUST be
connected to a standard, 230 Volt (50Hz) electrical supply, preferably through an ap-
proved plug , or a suitably fused isolator switch.
WARNING! THIS APPLIANCE MUST BE EARTHED
IMPORTANT: The wires in the mains lead are coloured in accordance with the following
code:
Green & Yellow ................................ Earth
Blue .................................................... Neutral
Brown ................................................ Li
As the colours of the flexible lead of this appliance may not correspond with the coloured
markings identifying terminals in your plug, or your mains supply, proceed as follows:
•
Connect GREEN & YELLOW coloured cord to plug terminal marked with a letter "E" or
Earth symbol "
" or coloured GREEN or GREEN & YELLOW.
•
Connect BROWN cord to terminal marked with a letter "L" or coloured RED.
•
Connect BLUE cord to terminal marked with a letter "N" or coloured BLACK.
Fuse Rating
The fuse in the plug must be replaced with one of the same rating (13 amps) and this
replacement must be ASTA approved to BS1362.
This appliance is fitted with a plug which is moulded on to the electric cable (i.e. non-
rewireable) please note:
1. The plug must be thrown away if it is cut from the electric cable. There is a danger of
electric shock if it is subsequently inserted into a socket outlet.
2. Never use the plug without the fuse cover fitted.
3. Should you wish to replace a detachable fuse carrier, ensure that the correct
replacement is used (as indicated by marking or colour code).
4. Replacement fuse covers can be obtained from most DIY or electrical stores.
Devils 4060, 4100 & 4120
These machines MUST be connected to a 400 Volt, 3 PHASE 50Hz supply through a suitably
fused isolator switch. It cannot be operated from a single phase supply.
A trailing socket is NOT provided, but is available from your CLARKE dealer,
Part No:
It is important to note, that the PLUG is wired as shown in the
illustration opposite, as viewed from the outside of the unit - the
socket should be wired correspondingly.
• The GREEN or GREEN & YELLOW coloured wire, is connected to
the terminal marked with the letter "E" or Earth symbol "
• The BLACK or Blue wire is connected to the 'N' or Neutral terminal.
• The Remaining wires are connected to the terminals marked L1, L2 and L3.
ve
"
4