Clarke 3110855 Інструкція з експлуатації Посібник з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Інструменти Clarke 3110855. Clarke 3110855 17 сторінок. 3” cut-off tool
Друкувати сторінку
ADJUSTING THE SPEED
The speed of the cut-off tool can be
adjusted using the screw-in regulator
in the tool body. A suitable screw-
driver will be required.
Turn the regulator clockwise or anti-
clockwise to suit.
CHANGING THE CUTTING DISC
WARNING: ENSURE AIR IS TURNED OFF AND TOOL IS DISCONNECTED
FROM THE AIR SUPPLY BEFORE REPLACING DISC.
1. Ensure the disc being fitted has a
speed rating greater than 21,000
RPM.
2. Install disc using spanner and hex
key supplied. Ensure that the
spacer is in place.
IMPORTANT: The use of parts other
than CLARKE replacement parts may
result in safety hazards, decreased
tool performance and may invali-
date your warranty.
Replacement cutting discs are available from your Clarke dealer. Part no
3110731.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the air supply hose until the compressor has been shut
down and the compressed air pressure released.
2. Once the pressure has been released, disconnect the air supply hose from
the tool.
MAINTENANCE
DAILY
1. Before use, drain water from air reservoir, air line and compressor as
appropriate.
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
7