Clarke IT1500 Інструкція з експлуатації та технічного обслуговування - Сторінка 12
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та технічного обслуговування для Інструменти Clarke IT1500. Clarke IT1500 17 сторінок. Induction heater
Друкувати сторінку
USE OF THE FLEXIBLE HEATING COIL
• Function: The flexible heating coil (7 in
the Overview on page 4) is used to clear
a bearing from an axle housing, frozen
O2 sensors, remove ball joints and tie rod
ends.
Expanding a piece to remove an interlocking
piece:
1. Follow the instructions for preparation of
operation and set up on page 8.
2. Insert one end of the flexible coil into the
one of the heating coil insertion ports and
tighten the locking knob.
3. Wind the coil at least 3 times around the work piece to be expanded,
making sure that the coil DOES NOT touch the work piece.
NOTE: It will heat faster as more coil is wound round the workpiece.
4. Insert the other end of the flexible heating coil into the remaining insertion
port and tighten the locking knob.
5. Press the heating switch to start the heater.
6. Heat until the workpiece has expanded enough to remove the bearing.
7. Release the heating switch and loosen both coil locking knobs to release
the heating coil.
USE OF THE FLAT HEATING COIL
• Function: The flat heating coil (3 in the
Overview on page 4) is used for
removing stickers, graphics, decals,
emblems, small body side mouldings and
pin striping.
Removing graphics:
1. Follow the instructions for preparation of
operation and set up on page 8.
2. Press the heating switch to start the heater.
3. Apply the flat heating coil near the end of
the related piece to be removed for a few
12