Clarke METALWORKER CMSSCS Інструкція користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція користувача для Інструменти Clarke METALWORKER CMSSCS. Clarke METALWORKER CMSSCS 8 сторінок. Metal shrinker/stretcher set

Друкувати сторінку

The lever stop bolt (see Figure 6) can be adjusted with a 3mm wrench to allow

the clamping lever to stop at the same location each time the lever is pulled

down.

NOTE: If the metal splits during the shrinking/stretching procedure, it is

typically because too much bend is trying to be achieved with

just a few heavy pulls of the lever. To avoid splitting, make pulls

lighter and increase number of pulls on lever. If metal still splits,

the radius of the desired bend may be too small for the metal, or

the metal is of the wrong type.

USING THE SHRINKER/STRETCHER

1. Verify the jaw teeth are free of

debris

2. Determine your job

requirements:

Using the shrinker, a curve in the

metal is created by compressing

the inside radius of a curve (see

Figure 7).

NOTE: Shrinking/stretching will create small teeth marks from the jaws

and cannot be avoided. Limit the depth of any teeth marks by

making more, lighter pulls with the lever.

CAUTION: WHEN THE TOOLS ARE NOT IN USE OR WILL BE PLACED IN STORAGE FOR

A PERIOD OF TIME, WE HIGHLY RECOMMEND REMOVING THE DIES FROM THE

TOOLS. IF THE LEVER IS ACCIDENTLY USED AND THE DIE JAWS CLAMP DOWN

AGAINST ONE ANOTHER INSTEAD OF A WORKPIECE, THE GRIPPING JAW TEETH

MAY BE DAMAGED.