CTP Systems dBbox2 Посібник - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник для Випробувальне обладнання CTP Systems dBbox2. CTP Systems dBbox2 17 сторінок. Version 3 firmware

Input> AES BNC

are continuously monitored so a brief error may not be noticed. When set to

"sticky" an error once set will be continuously displayed even if the signal has

recovered from the error.

Input> AES BNC

Sample rate

Audio bits

Emphasis

Generation

Format

Only while reading channel status some sample rates may sound distorted through

the loudspeaker or headphones as it's necessary to switch off some synchronising

functions to efficiently calculate the sample rate.

Input> AES BNC

This displays the first five (and most important) bytes of the AES status word in

binary format.

Errors type>

Ch.Status

Sample rate is calculated directly from the incoming clock.

Possible displayed values are 32kHz, 44.1kHz, 48kHz, 64kHz,

88.2kHz, 96kHz, 176.4kHz and 192kHz. Any other sample rates

will be displayed as '???'.

Possible readable values 16 bit, 20 bit, 24 bit.

On or off.

Original or Copy

Yes or No.

Possible data types PCM, IEC61937, DTS_LD, DTS_CD.

Stat.word

loop or sticky

When set to "Loop" any errors

Shows the channel status of the

AES signal. Possible readings are: