CTR TMX Series Посібник з вирівнювання - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з вирівнювання для Гравер. CTR TMX Series. CTR TMX Series 7 сторінок.

LASER MACHINE MANUFACTURER

3. Close the laser machine lid and press the Laser (on Leetro) or Pulse (on RD Controller)

key on the laser machine keypad firmly for one second. The laser should fire, leaving a

burn mark on the masking tape (image below).

NB: If the laser doesn't fire, press Esc on the laser machine keypad and repeat this step.

Brass mirror

adjustment

screws

4. With the masking tape left in place, move the laser head to the front left-hand side of the

laser machine bed.

5. Close the laser machine lid and press the Laser (on Leetro) or Pulse (on RD Controller)

on the laser machine keypad firmly for one second, so that the laser machine fires a

second burn mark on the masking tape.

The two burn marks should be on top of each other. If they aren't (image example

below), you will need to adjust the brass mirror adjustment screws to correct the

alignment, so that the two burn marks are on top of each other.

The above image shows an example of the laser having fired and

burned a mark onto the masking tape at the top of the lens assembly.

CTR Future | Instructions | Laser Alignment rev. 10.03.2020 | Page 3 of 7