Lenovo 501LV Безпека, гарантія та швидкий старт - Сторінка 13

Переглянути онлайн або завантажити pdf Безпека, гарантія та швидкий старт для Планшет Lenovo 501LV. Lenovo 501LV 15 сторінок.

Federal Communications Commission (FCC) Declaration of Conformity

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

This device has been tested and found to comply with the limits for a Class B digital,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment

generates, uses and can radiated radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communica-

tions. However, there is no guarantee that interference will not occur in a particular

installation If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

-Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:

Changes or modiﬁcations not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

FCC RF Exposure Information (SAR)

This device is designed and manufactured not to exceed the emission limits for exposure

to radio frequency (RF) energy set by the Federal Communications Commission of the

United States.

During SAR testing, this device is set to transmit at its highest certiﬁed power level in all

tested frequency bands, and placed in positions that simulate RF exposure in usage near

the body. Although the SAR is determined at the highest certiﬁed power level, the actual

SAR level of the while operating can be well below the maximum value. This is because

the device is designed to operate at multiple power levels so as to use only the power

required to reach the network. In general, the closer you are to a wireless base station

antenna, the lower the power output.

The exposure standard for wireless employs a unit of measurement known as the Speciﬁc

Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg.