Acorn CB200 Посібник із застосування - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник із застосування для Система безпеки Acorn CB200. Acorn CB200 11 сторінок. Conventional control panel
Друкувати сторінку
Written by: R Patel
2.2 Engineer Facilities
2.2.1 Mechanical Assembly Illustration
Terminal cover
Company logo
PCB terminals
Display cover
3. Panel Configuration
3.1 Buzzer Enable Link
The "Link for Buzzer Enable" link, located at the top right corner of the Control Board, is a
buzzer disable/enable facility. Its purpose is to disable the buzzer should this be helpful
during commissioning. DO NOT remove this link except in exceptional circumstances.
This link is not monitored by the control board and no faults or indications of any kind will
be generated if the link is removed.
3.2 Engineer's Control
This facility is located on the top right hand corner of the PCB. Its functions are described
below:
3.2.1 Processor Reset
Press to reset if the "Processor Fault" LED illuminates
3.2.2 One-man Test
If pressed for more than 5 seconds the panel will go into One-man Test mode.
3.2.3 Zone 1 Non-latch
Setting the zone 1 non-latch DIL switch to the ON position causes zone 1 to operate
in a non-latching fire indication mode. In this mode, if a fire condition occurs on zone
1 the panel will indicate the fire condition and operate the alarms. The auxiliary fire
Document No.: CBAPP Rev.: 7
www.acornfiresecurity.com
AJC
Checked by:
Fixing screws
LED indications
+
Battery leads
User controls
Red/Black
-
Battery link (Blue)
- 1-2 Zone Panels
:
Page 4 of 11
Pre-formed
Semi-flush
Key hole
Removable gland
bezel
top fixing
plate with
protection plugs
PCB support
Battery space
Mains terminals
Transformer
-
2 x 12v 2.1 Ah batteries
+
Date: 06/06/2003