Nikon Coolpix 990 Інструкція з налаштування
Переглянути онлайн або завантажити pdf Інструкція з налаштування для Аксесуари для фотоапаратів Nikon Coolpix 990. Nikon Coolpix 990 2 сторінки. Recommended camera settings for oneshot360
Також для Nikon Coolpix 990: Примітка до випуску (4 сторінок), Посібник зі швидкого прискорення (1 сторінок), Короткий довідник (4 сторінок), Відгуки користувачів (50 сторінок), Посібник із швидкого старту (2 сторінок)
Nikon 990 Instructions for OneShot360
Recommended Camera Settings for OneShot360
•
When turning the CoolPix990 on, put it in M-Rec mode by turning the power dial two
clicks over from the OFF position.
•
Set the Image Quality to Full-Fine by holding down the "QUAL" button and rotating the
command dial until you see it change from "XGA FINE" to "FINE". This is the Full-Fine
setting.
•
Use the Zoom to exactly fill the digital camera LCD viewer screen with the circular image.
If you zoom in too much, you will lose part of the field of view. If you zoom in too little, you
will not get maximum resolution. Note also that the OneShot image may not be exactly
centered in the LCD screen – this is normal.
•
Disable the flash by pressing the center button below the LCD screen until the "flash-
disabled" icon appears in the top corner of the display.
•
Manually set the Focus by holding the "M-focus" button and dialing in a distance with the
command dial. A distance of 20 feet is recommended for most shots.
•
Note: The button for placing the camera in manual focus mode is the same as that for
setting the timer. If you want to use both the timer and a manual focus setting, you must
enable the timer first by pressing the "m-focus" button until you see the timer icon in the
LCD, then hold the button down and dial in the focus distance. Pressing the "M-focus"
button again will set camera back to auto focus mode.
•
Set the camera to aperture priority ("A") mode. This is done by holding down the "MODE"
button and rotating the command dial until the letter "A" appears in the lower left hand
corner of the LCD screen.
•
Now select an aperture value, which is displayed in the lower middle portion of the color
LCD. Rotate the command dial to select the aperture. We recommend using an aperture
setting of f7.0.
Take care to watch the shutter speed when in aperture priority mode. If the light level is low, you
will need a tripod when the shutter speed is slower than 1/125sec. The shutter speed is displayed
on the bottom of the LCD panel between the "A" mode and the "F7.0" display.
By pressing the "MENU" button just above the color LCD screen, you will have access to a list of
additional camera settings. Use the Multi selector button to scroll through the menu and make
your selection for the following:
•
Set the white balance. Automatic setting is usually adequate.
•
Set the Metering to Matrix Metering, this gives the best results for OneShot360 images.
•
Set the Sharpness value to "Normal".