Nikon WR-R10 Посібник

Переглянути онлайн або завантажити pdf Посібник для Аксесуари для фотоапаратів Nikon WR-R10. Nikon WR-R10 6 сторінок. Wireless remote controller/wr adapter
Також для Nikon WR-R10: Посібник користувача (2 сторінок), Посібник користувача (2 сторінок), Посібник із швидкого старту (6 сторінок), Посібник користувача (6 сторінок)

Updating the Firmware for WR-R10 Wireless

Remote Controllers

Thank you for choosing a Nikon product. This guide describes how to update the ﬁ rmware for

WR-R10 wireless remote controllers. If you are not confi dent that you can perform the update

successfully, the update can be performed by a Nikon-authorized service representative.

See the manual provided with your Nikon product for information on use.

Important

The product may be damaged if power is interrupted or the controls are operated during

the update. Do not turn the product oﬀ , remove or disconnect the power source, or attempt

to operate the product during the update. If the update is not completed successfully and

the product becomes inoperable, take it to a Nikon-authorized service representative for

inspection.

Get ready

To perform the update, you will need:

• A WR-R10 wireless remote controller

• A camera that can be used to update the WR-R10 ﬁ rmware (a D7100 is used in

this guide for illustrative purposes)

• A computer equipped with a card reader or card slot

• One of the following camera power sources:

— An AC adapter

— A fully-charged battery

• A Nikon-approved memory card that has been formatted in the camera (note

that all data on the memory card will be deleted when the card is formatted;

before formatting the card, back up any data you wish to keep to a computer

or other device)

• The manuals for the camera and WR-R10

Windows

– Windows –