Cub CB-1034i Посібник зі швидкого встановлення - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник зі швидкого встановлення для Зчитувач штрих-коду Cub CB-1034i. Cub CB-1034i 4 сторінки.

Друкувати сторінку

Cub CB-1024i and CB-1034i

Quick Start Installation Guide

Label Installation

Label and Ribbon Loading Path

7. Close the print head

mechanism by applying

downward pressure. The

printhead release levers will

'click' when locked in place.

Performing Media Calibration

Once you have loaded the ribbon and labels as shown above it will be necessary to perform a

media calibration. The media calibration allows the printer to determine what size label has been

loaded and if a ribbon is being used. Failure to calibrate the printer may cause errors such as NO

PAPER, PAPER JAM & NO RIBBON to be shown on the printers LCD display. Follow the steps below

to perform a media calibration.

1. Make sure the ribbon and label media are installed properly as described.

2. With the printer power off press and hold the printer's

3. Power the printer on. Do not release the

Calibrating.

4. The Printer will advance several labels, feeding the last label to the label perforation.

Once completed the printer's LCD display will read Ready.

5. Should there be any errors on the LCD display please see the troubleshooting section of the

users guide.

** More Information about your Cub CB-1024i can be found in the User's Guide

on the provided installation CD. **

PAUSE

button.

PAUSE

button until the printer's LCD display reads

Printer Self-Test

To verify the printer is functioning correctly, initiate a printer self-test. The self-test can be performed

after the media calibration is complete and before installing the printer on your host PC. Follow the

steps below to perform a self-test.

1. Install ribbon and label media and successfully perform media calibration.

2. Press the

button on the printer's front panel.

3. Press the

DOWN

button until

Diagnostics

is highlighted.

4. Press the

SELECT

button.

Print Config.

will now be highlighted, press

6. Press the

DOWN

button until

exit

is highlighted once highlighted press the

7. Press the

DOWN

button until

exit

is highlighted once highlighted press the

The printer's LCD display should now read Ready.

8. Please note that the self-test is pre-formatted to print on a 4 inch wide label. When using a smaller

label some self-test information may run off the side of the label and not print.

Your Cub CB-1024i is now ready to be installed on your host PC. Please see the Installing Windows Print

Driver guide to complete printer installation on your host PC. This guide will also walk you through

installing the provided Seagull Scientific BarTender UltraLite label creation software.

Network Printing

The following steps are for network printing applications only. When connecting your printer to

the host PC via USB, parallel or RS-232C interfaces these steps do not apply.

Viewing Network Status

To view the current network settings follow the steps below.

1. Press the

button on the printer's front panel.

2. Setup will now be highlighted press the printer's

3. Press the printer's

DOWN

button until Ethernet is highlighted, once highlighted press the printer's

SELECT

button.

4. Status will now be highlighted. Press the printer's

Cub CB-1024i and CB-1034i

Quick Start Installation Guide

SELECT.

The printer will now print a self-test label.

SELECT

button.

SELECT

button.

SELECT

button.

SELECT

button to view it's Ethernet status.

continued...