CLASSÉ AUDIO P-100 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач CLASSÉ AUDIO P-100. CLASSÉ AUDIO P-100 11 сторінок. Power amplifier

CONNECTIONS FOR REGULAR OR BALANCED INPUTS:

The CLASSÉ P-100 power amplifier is equipped with both regular and balanced inputs.

Either one may be used

connected to a preamplifier which has balanced main outputs, and balanced interconnects with

connectors are also required.

REGULAR INPUTS

Remove the amplifier top and make sure the

on the main

circuit board are installed to the positions marked

PCB

Replace top. (The amplifier is factory set for regular use.) Connect the regular interconnects to the

input jacks on the rear panels of the P-100. The balanced connectors are automatically disabled.

RCA

BALANCED INPUTS

Remove the amplifier top and make sure the

on the main PCB circuit board are installed to the positions marked

3) Replace top. A balanced preamplifier and balanced interconnects are also required. For use with

balanced preamplifiers other than Classé, the wiring of the 3-pin

that of the CLASSÉ P-100 which is wired as follows:

PIN 1: GROUND

PIN 2: POSITIVE (NON-INVERTED) SIGNAL

PIN 3: NEGATIVE (INVERTED) SIGNAL

If the pin configuration on the preamplifier differs from above, the balanced interconnects must be

modified to accommodate the different preamp.

Having confirmed the correct connections, plug the

interconnects into the locking

connectors, press the tab above the connector.)

SEPARATELY, BUT NOT SIMULTANEOUSLY

connectors on the rear panel of the P-100. (To remove the

XLR

. The balanced inputs must be

REGULAR/BALANCED

"REGULAR"

REGULAR/BALANCED

"BALANCED"

connectors must be matched to

XLR

-7-

jumpers of both channels

. (See Fig 1 and Fig 2)

jumpers of both channels

. (See Fig 1 and Fig

connectors of the balanced

"XLR"