Dirty Hand Tools 101571 Посібник з експлуатації - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Румпель Dirty Hand Tools 101571. Dirty Hand Tools 101571 20 сторінок. 15” front tine tiller

Друкувати сторінку

Operating Instructions

Preparation for Operation

THIS UNIT WAS SHIPPED WITHOUT OIL IN THE

ENGINE. Check the oil level before each operation.

Fill Engine with Oil

1. Add oil according to engine manual. Do not over ll. Use

SAE30 engine oil. Do not mix oil with gasoline. Oil level

must be full. Check the oil level by removing oil ll plug (see

Figure 9). Oil level should be up to the bottom of the ll plug

opening.

Pre-Start Inspection

1. Make sure safety shields are in place and nuts & bolts are

secure.

2. Check oil level.

3. Inspect air cleaner (see Figure 10). Clean or replace as needed.

4. Check fuel supply. Fill the fuel tank no closer than 1 inch

from top of tank to provide space for expansion.

5. Be sure spark plug wire is attached and is tightened securely.

6. Examine underneath and around engine for oil or fuel leaks.

7. Inspect fuel hoses for tightness and fuel seepage.

8. Look for signs of engine damage.

9. Remove excessive debris from mu er area and recoil starter.

Adjusting the Depth Regulator

Remove the depth regulator, turn in opposition direction and

reinstall with two locking pins (see Figure 11). Adjust the depth

regulator up or down as required.

WARNING

RECOIL

FUEL FILL

STARTER

Figure 9

Figure 10

Figure 11

OIL FILL

LOCKING

PINS