Dirty Hand Tools 103350 Посібник з експлуатації - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Румпель Dirty Hand Tools 103350. Dirty Hand Tools 103350 16 сторінок. 10” mini-cultivator

Друкувати сторінку

Preparation for Operation

Pre-Start Inspection

1. Make sure safety shields are in place and nuts & bolts are secure.

2. Check fuel supply. Fill the fuel tank no closer than 1 inch from

top of tank to provide space for expansion.

3. Inspect air lter. Clean or replace as needed.

4. Be sure spark plug wire is attached and is tightened securely.

5. Examine underneath and around engine for oil or fuel leaks.

6. Inspect fuel hoses for tightness and fuel seepage.

7. Look for signs of engine damage.

8. Remove excessive debris from mu er area and recoil starter.

Filling with Oil and Gasoline Mixture

Mix unleaded gasoline with 2-cycle engine oil at a ratio of 40:1

in a separate container and add to the fuel tank before starting

1. Place the cultivator on a level surface outdoors in a well-

ventilated, dry area, away from building air intakes.

2. Mix one gallon of 87+ octane gasoline with 3 ﬂ. oz. of two-

stroke engine oil in an approved container. Slowly shake the

container to thoroughly mix the gasoline/2-cycle oil.

Do not run the engine with an improper gasoline/2-cycle oil

mixture. Running the engine with an improper mixture WILL

permanently damage the engine and void the warranty.

• Always ﬁll the tank with the engine oﬀ and cool.

• Always check the fuel level before operation.

• Allow the engine to cool for at least two minutes before

removing the fuel cap.

• Do not ﬁll with fuel indoors or near any source of combustion.

• Do not smoke when fueling or operating the cultivator.

• Do not overﬁll with fuel.

Checking Transmission Oil

e transmission oil is ﬁlled at the factory. Should it require

ﬁlling use SAE30 engine oil and ﬁll to top of the reservoir (see

Figure 3).

WARNING

the engine.

WARNING

FUEL MIX:

40:1

3 FL. OZ.

GALLON

2-CYCLE

GAS

OIL

MIX

TRANSMISSION

OIL FILL

Figure 3