Dirty Hand Tools 104001 Посібник з експлуатації - Сторінка 19

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Електроінструмент Dirty Hand Tools 104001. Dirty Hand Tools 104001 20 сторінок. Vibratory plate compactor

Друкувати сторінку

1. Exciter Lubrication

Troubleshooting

PROBLEM

Engine will not start

Engine runs rough, floods during operation

Engine is hard to start

Engine misses or lacks power

Engine will not stop when throttle control

is positioned at stop

Soil is difficult to compact

Plate compactor is difficult to control when running

(machine jumps or kicks back)

Poor compaction of material

SOLUTION

• Add gas to gas tank.

• Connect spark plug wire to spark plug

• Fuel valve must be open

• Throttle must be positioned at choke for a cold start

• Clean or replace air cleaner

• Drain old fuel and replace with fresh. Use gas

stabilizer at end of season

• Make sure spark plug wire is securely attached to

spark plug

• Throttle is not in proper start position

• Remove and clean fuel tank

• Clean or replace air cleaner

• Improper carburetor adjustment, take to authorized

engine service center

• Check and replace spark plug and adjust gap

• Drain and refill gas tank and carburetor

• See engine manual to check and adjust the

throttle or remove any debris blocking the linkage

• Soil is too dry. Add moisture to the ground by lightly

sprinkling water with garden hose, then allow the

surface to dry

• Engine speed is too high. Adjust the engine's throttle

• The material to be compacted is too hard or dense

• The material that is being compacted has reached

maximum level of compactness

• The engine throttle is set too low. Adjust the throttle

and allow several passes to reach maximum level of

compactness