Dirty Hand Tools 104001 Посібник з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Електроінструмент Dirty Hand Tools 104001. Dirty Hand Tools 104001 20 сторінок. Vibratory plate compactor
Друкувати сторінкуHANDLEBAR
END
Figure 1
Figure 2
Handlebar and Wheel Assembly
Mounting the Handlebar Assembly
1. Unfold the handlebars (see Figure 1).
2. Place the handlebar ends into the mounting channels on the engine's
deck, carefully aligning the holes in each side (see Figure 2). Secure
the handlebar ends to the channel with a hex bolt (M10x65mm), flat
washer and locknut.
3. Position the throttle control onto the upper portion of the handlebar
and secure with a flat washer and hex bolt (M5x25mm).
Mounting the Folding Wheel Assembly
1. Position the folding wheel assembly at the rear of the plate compactor.
Line up the holes in the mounting links with the holes in the engine
deck and secure with hex bolt (M10x30mm), flat washer and lock nut
on each side (see Figure 3).
THROTTLE
CONTROL
MOUNTING
CHANNEL
FOLDING
WHEEL KIT
Figure 3
9