Disc Makers MacElite 4 Посібник користувача - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник користувача для Дисковий дублікатор Disc Makers MacElite 4. Disc Makers MacElite 4 17 сторінок. Elite series

Друкувати сторінку

Installing Input and Output Spindles

Locate the 3 Input and 1 Output rods. Screw in the input rods in the designated

labeled area located in the front right of the base of the Elite system.. Screw in

the Output rod to the right of the Input area.

Connecting the duplicator to a computer

Power down the selected host computer.

Printer USB

Printer DC Input

AC Power Connector

Duplicator Power

Plug one of end of a USB cable into the connector labeled USB to PC on the back of

the duplicator cabinet. Plug the other end of the cable into a USB 2.0 port on the

selected Macintosh host computer.

Note: USB 1.0 interfaces cannot handle the data transfer rates required for disc duplication

tasks. If your system has USB 1.0 ports, you must upgrade to USB 2.0 to use the duplicator.

Connecting the power and printer cables

Note: After connecting the power cables, as described in the following steps, do not

power up the system until you have completed the procedure in the next section, titled

Elite2 for Mac Getting Started Guide

Printer Control

USB to Disc Drives

USB to PC