Disc Makers Reflex 1 Посібник із швидкого старту
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Комп'ютерне обладнання Disc Makers Reflex 1. Disc Makers Reflex 1 2 сторінки. Cd-r
Друкувати сторінкуBASIC OPERATION
This Quick Start Guide has basic instructions for
duplicating "Disc-to-Disc," which is copying CDs from a
master CD placed in the unit's top drive. For more
detailed instructions on the Reflex 1 CD's duplicating
operations, please refer to the User's Guide on the
attached CD.
Power on the Reflex 1 CD-R by
pressing the round button located at the
bottom right on the front of the unit. The
system will initialize and perform a self
test, which will be shown on the LCD
display.
When the self test is complete, the
"1. Copy" display will appear on
the LCD screen. Press the DOWN arrow
until "8. Select Source" appears on the
LCD display.
Press the ENT button and the
following image should appear on
the display:
If so, Hit ESC and proceed to step 5.
If not, press the DOWN arrow until it
displays. "SRC: CD-ROM 01 IDE2
Slave. Press the ENT button and the LCD
will display CD-ROM selected!. Press
ENT again.
Press the UP arrow until you return
to "1. Copy" To start the duplication
process, load the top drive with your CD
master. Load the bottom, writer drive with
blank CD-R / RW media.
Press the ENT button to begin
duplicating. The Reflex duplicator
will automatically analyze the master disc
(this may take a few moments), and begin
duplicating at the maximum recording
speed.
The LCD will display the writing
process as it happens. The screen
will display "OK:" when the duplication is
complete.
Note: When the duplication process is
completed, the writer drive will automatically
eject the CD-R / RW that has been duplicated
successfully. If the duplication process failed,
the CD-R / RW will remain in the drive until the
eject button on the drive is pressed. For more
information on why a CD-R / RW may not copy,
please refer to the User's Guide on the attached
CD.
Basic use of Reflex USB Connect
Make sure the Reflex and
computer are off before beginning.-
Connect USB cable to the back of the
Reflex and to the computer.
Push switch on the back of the
Reflex unit to the right for USB (towards
the USB connector), Turn on computer &
Reflex unit, the red led will light.
Wait 30 sec., Windows system
message "Found New Device" may
appear during the first time setup.
The Reflex will appear as a "USB
Mass Storage Device". Follow any on-
screen instructions for setting up a USB
device.
In Windows Explorer & My
Computer, the single bottom writer drive
on Reflex1 units will appear as a Compact
Disc Drive icon
The drive is now ready to read and
write to using provided software or other
authoring software. (Please see software's
help for its use)
To use the Reflex with out a
computer, turn off the Reflex only, push
the switch to the left (away from the USB
connector) Turn the Reflex back on you
can now use the Reflex as a standalone
duplicating machine.