Disc Makers ReflexPro7 Інструкція з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Комп'ютерне обладнання Disc Makers ReflexPro7. Disc Makers ReflexPro7 13 сторінок. Cd-r disc duplicator reflexpro series
Також для Disc Makers ReflexPro7: Посібник із швидкого старту (2 сторінок), Посібник користувача (15 сторінок)
Друкувати сторінку•
disc will be ejected when the data is loaded to the hard drive. In case
of error, the LCD will show ERROR and the master disc will be ejected
automatically.
•
To begin the duplication operation, switch back to the COPY function
by pressing the STATUS button. Load the CD writers in the system with
high quality blank CD-R media. The ReflexPro will begin duplicating
when all writers detect the blank media. If four or seven writers (depend-
ing on the configuration) are not utilized, the LCD display will show the
number of CD-R blanks detected as XSTART. ( X represents the number
of writers that are ready to duplicate). Press the START button and
duplication will begin immediately.
•
When the duplication process is completed, the CD writers will auto-
matically eject discs that have been duplicated properly. Discs that have
not been duplicated properly will remain in their respective writers. Press
the STATUS button and the bad discs will be ejected automatically, or
press the eject button on each individual CD writer.
•
The ReflexPro will show an error message if you attempt to duplicate
from a hard drive partition that contains no data. Switch to the LOAD
function to import data to the appropriate partition.
•
Do not press any buttons on the ReflexPro during the duplication pro-
cess. This will interrupt the duplication session and ruin the CD-R media.
FUNCTIONS
The Reflex features numerous functions that make it an advanced CD duplication/pro-
duction system. The following functions can be accessed on the front panel by pressing
the STATUS button.
Copy
Make sure the present partition in hard drive is correct and contains data before
copying. Place blank CD-Rs into the CD writers. When all writers detect the
CDs, the Relfex will start duplicating automatically. When fewer copies are
needed, place the required number of blank CD-Rs into the CD writers. When you see
the number X in XSTART, that matches the number of blank discs placed in the CD
writer(s). Press the START button to start duplication.
When the duplication process is finished, those discs duplicated properly will be
ejected automatically and failed ones will remain in the CD writers. Press the STATUS
button to eject those failed CD discs. Put new CD-R media in the writers for additional
duplicates.
T
www.discmakers.com
1-888-800-4041
6