Cub Cadet 190-341-100 Інструкція з монтажу та обслуговування - Сторінка 11
Переглянути онлайн або завантажити pdf Інструкція з монтажу та обслуговування для Снігоочисник Cub Cadet 190-341-100. Cub Cadet 190-341-100 20 сторінок. 42" snow thrower attachment for cub cadet series 2000/2500 tractors
Також для Cub Cadet 190-341-100: Посібник оператора (20 сторінок)
Друкувати сторінку
A. SNOW THROWER INSTALLATION.
WARNING: Before installing the snow
thrower
assembly
ensure the PTO switch and ignition
switch are in the OFF position, the park-
ing brake is locked, and that the exhaust
system and surrounding areas have ade-
quately cooled.
NOTE: To ease insertion into the tractor frame
channels, apply a light coating of grease to the channel
brackets of the snow thrower hitch assembly ( Refer to
Figure 17).
1. Position the snow thrower assembly directly in
front of the tractor with the subframe assembly
extending rearward.
NOTE: Because of lower ground clearance on tractors
equipped with 15" front tires and 20" rear tires, the
gearbox mounting bracket, as assembled on the snow
thrower subframe, may not clear the front axle of the
tractor. Note that steps 2, 3 and 6 apply only to these
tractors.
2. Units with 15" front tires ONLY. Remove the
front hex flange lock nuts and cap screws securing
the gearbox mounting bracket to the subframe
arms. Loosen the rear fasteners. See Figure 15
LOOSEN
REAR
FASTENERS
GEARBOX
MOUNTING
BRACKET
Figure 15
SECTION III. INSTALLATION AND REMOVAL
onto
the
tractor,
REMOVE
FRONT
FASTENERS
SUBFRAME
ARM
3. Units with 15" front tires ONLY. Using care to
avoid separating the rear half of the drive shaft
from the front half, tilt the gearbox mounting
bracket rearward. See Figure 16.
NOTE: Turning the tractor's front tires fully to the left or
right will slightly raise the front axle of the tractor and
provide more ground clearance.
DRIVE SHAFT
HALVES
4. Slide the snow thrower assembly rearward until
the channel brackets of the hitch assembly engage
the frame channels of the tractor. See Figure 13.
FRAME
CHANNEL
LIFT HANDLE
11
GEARBOX MTG.
BRACKET TILTED
REARWARD
Figure 16
CHANNEL
BRACKETS
FRONT LIFT
SHAFT
Figure 17