Blade Inductrix200 Інструкція з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Квадрокоптери Blade Inductrix200. Blade Inductrix200 17 сторінок.
Друкувати сторінку
Transmitter Setup
Program your transmitter before attempting to bind or fl y
the quadcopter. Transmitter programming values are shown
below for the Spektrum DX6i, DX7s, DX6, DX7, DX8, DX9
and DX18.
The fi les for models using Spektrum
™
AirWare
software are also available for download online
at www.spektrumrc.com.
Your quadcopter is also compatible with Spektrum DXe
radios with software version 1.3 or higher. Use the directions
below to reverse channel 6, or use the appropriate program-
ming cable and the PC or mobile app to program the DXe.
We recommend downloading the Blade
model setup available at www.spektrumrc.com.
DXe
To use the DXe transmitter with the Blade Inductrix, channel 6 must be reversed.
To reverse channel 6:
1. While powering on the DXe, hold the left and right sticks in the top-inside corners
as shown.
2. Re-center the sticks after the transmitter beeps. The LED will fl ash slowly.
3. To select a channel to reverse, move the right stick to the left or right and allow it
to re-center. Move the stick to the right to select the next channel. Move the stick
to the left to select the previous channel. The LED will fl ash rapidly corresponding
to the channel selected, as shown in the table. Select channel 6.
4. To reverse the selected channel, move the right stick up or down. The LED will
change color to indicate the new channel direction.
The LED will fl ash Orange to indicate the channel is normal.
The LED will fl ash Red to indicate the channel is reversed.
5. To store the changes, power off the DXe.
CAUTION: During the subsequent power up, always verify the throttle
direction is correct and keep clear of the motor and rotor blades. Failure to do
so may result in injury or damage to the product.
After reversing channel 6, bind the transmitter and
quadcopter normally.
Flight modes are controlled by the Flight Mode switch.
Motor Stop is controlled by the Bind/Panic/Trainer button.
™
transmitters with
®
Inductrix
™
DXe
5
If you are programming your DXe using the PC or mobile
app, make sure the "Transmitter Channels" value is set to
the default of 7. If for any reason this value is changed
to 9, the Inductrix will bind to the DXe, but will not respond
to control inputs.
If your DXe was included in another Blade Ready To Fly (RTF)
helicopter, the transmitter software will have to be updated
using the appropriate programming cable and either the
PC or mobile app available at www.spektrumrc.com.
Please note, the switch confi guration used for DXe transmit-
ters included with the Blade 230 S RTF and Micro AH-64
Apache RTF varies from the standard DXe layout.
Once bound, the LED in the quadcopter should glow
blue for fl ight mode 0 (Stability, low angle mode), green
for fl ight mode 1 (Stability, high angle mode) and red for
fl ight mode 2 (Agility mode).
If the motors will not start when giving the correct start
command, channel 6 has not been reversed correctly. Use
the directions above to reverse channel 6.
LED Flashes
Channel
1
1-Throttle
2
2-Aileron
3
3-Elevator
4
4-Rudder
5
5-Flight Mode
6
6-Motor Stop
7
7-Flaps
8
8-Aux Channel
EN