Discount Car Stereo A2D-MB23 Посібник з монтажу - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільна стереосистема Discount Car Stereo A2D-MB23. Discount Car Stereo A2D-MB23 7 сторінок. Bluetooth music streaming for sprinter and blaupunkt aux ready radios
Друкувати сторінкуOperation
Turn ignition and radio "ON"
1.
Press CD or button combination to enter AUX mode.
2.
Launch Smartphone or tablet streaming application
3.
Use radio volume control button to set playback level.
4.
Playlist and Track selection is *NOT* possible from
the radio. You must use audio devices built-in
controls to access audio files.
If correct operation is confirmed go ahead and push radio back into
5.
slot
Engine Noise:
Some report getting noise that increases with engine speed.
experience alternator whine (noise increases with engine speed), We
recommend adding a noise filter (e.g. NF3A) to power/ground supply lines
(red/black wires)
Here is how to add Noise Filter:
Noise filter is installed between 8-pin female plug (To radio) and Bluetooth
module as seen in Fig.8 (Do not cut factory harness)
If necessary, remove black tape from wires near 8-pin female plug
(You will be working on the black/red wires going to Bluetooth module)
a. Cut red and black wires about 2 inches away from 8-pin plug
b. Mate red wire from module with red wire from filter labelled OUT
c. Mate black wire from module to black wire from filter labelled
OUT
d. Mate red/black wires from 8-pin plug to black/red wired on filter
labelled IN.
If you
Fig. 8