Discount Car Stereo IL-CR12 Швидкий старт установки - Сторінка 2

Переглянути онлайн або завантажити pdf Швидкий старт установки для Автомобільна стереосистема Discount Car Stereo IL-CR12. Discount Car Stereo IL-CR12 3 сторінки. For porsche cr1 & cr2 radios

Друкувати сторінку

PRODUCT SAFETY & DISCLAIMER

READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE

PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY

•

This installation guide is provided as a GENERAL installation guide, some vehicles vary and

may require additional steps. We do not accept responsibility for third party labor charges

or modifications. Exercise due-diligence when installing this product.

•

We do not accept any responsibility for vehicle damage or personal injury resulting from

the installation of this product.

Careless installation and operation can result in equipment damage

Introduction:

For those adamant about keeping their vehicle's stock radio, we offer a simple

upgrade that allows the factory radio to support new technology. The IL-CR12

allows Porsche CR-1 & CR-2 cassette radios in the 911, 944, 964, 968, 993 to

charge and play music files from Apple's latest iPods, iPhones and Tablets

including iPhone 6s, 6

, 7, 12

etc. Because this adapter connects directly to the

radio "CD" por, the factory CD changer (if present), must be disconnected.

Installation:

Although not critical, we recommend disconnecting the car

battery. Keep in mind all CR-1/2 radios are coded and will

not operate without the code. Radio code must be available

for radio to operate upon reconnection.

Radio removal required to gain access to connectors.

Remove trim ring and ensure both tabs are centered at which point

radio is pulled from dash (grasping the cassette opening provides

some leverage) or push from rear.

2. With radio removed, disconnect CD changer (if present) 13-pin plug

(See. Fig. 1) from radio.

3. Connect adapter 13-pin plug to "CD" connector on radio (See Fig. 2)

13-pin Plug

Fig. 2

Radio connector

4. Run/route Lightning plug (See Fig. 3) to desired mounting location on

dashboard, glove box, console etc. (within 4 ft. of radio).

to not cut, pinch or crimp the cable during this step.

Fig. 1

Use caution