Aereco HAT-100-B Технічна та експлуатаційна документація - Сторінка 9

Переглянути онлайн або завантажити pdf Технічна та експлуатаційна документація для Вентилятор Aereco HAT-100-B. Aereco HAT-100-B 12 сторінок.

TECHNICAL AND MAINTENANCE DOCUMENTATION HAT

6. USE

The fans require periodical service twice a year which must include checking the general

condition and cleaning the impeller and the housing. Before operation, service or repair of

the device, it is necessary to make sure that

the employee performing the inspection has been trained and knows the safety rules,

the power supply is disconnected (circuits of all poles) and that it is not possible for

third parties to switch on the fan,

the fan impeller is no longer rotating.

The fan bearings do not require lubrication and should be replaced if faulty.

Do not use pressurised equipment (compressed air or pressurised water) to clean

the fans.

When cleaning, make sure that the weights balancing the impeller are in place and

the impeller is not deformed.

After cleaning, make sure that the fan works without any abnormal noises.

Check that the impeller is not jammed and that the motor protection is not loosened.

HAT fans are factory packed in appropriate cardboard boxes. It is recommended to leave

the fans in their original packaging during the whole transport to the place of installation.

During transport, the fans should not be thrown, knocked over or additionally weighted.

Prior to mounting, the fans should be stored in dry and well-ventilated spaces.

AERECO S.A. RESERVES THE RIGHT TO MAKE CHANGES TO THIS TECHNICAL

www.aereco.com

MANUAL WITHOUT NOTICE.

ATTENTION!!!

Service notifications should

be made via the website:

www.serwis.aereco.pl

Start-up must be documented

by an entry in the warranty

card.

ATTENTION!!!

Failure to carry out the

inspection will result in the

loss of warranty.