ARNETOLI MOTOR F 202 M Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Аксесуари для газонокосарок ARNETOLI MOTOR F 202 M. ARNETOLI MOTOR F 202 M 2 сторінки.
Друкувати сторінку
- How to change the trimmer line
Changing the trimmer line is a simple operation. Be sure you use a quality trimmer line, otherwise your line will break
often and create unnecessary hassles. We recommend you use our MAXI-LINE - a high resistant line which not only
increases the effectiveness of the brush cutter head but also eliminates any chance of the line getting stuck together.
1. Unscrew the bottom part of the
head using the apposite wrench
4. Reel the same lines in the middle of
the spool and wind
7. When finished rolling up the line, place the
line in the retainer slits to keep it from unra-
velling (its recommended to leave at least
4 inches of line to ease step number 8)
- If the line doesn't come out
This can be caused by any of the following reasons.
• Has the line been wound up correctly, without crossing over (fig. 6)?
• Once the outer reel was replaced, did you pull and remove the lines from the retainer slits (fig. 9)?
• Is the trimmer line used of poor quality?
• Is it blocked because the knob is dirty?
Remember that proper maintenance and an occasional cleaning of this tool will not only prolong its' life but also prevent product
failure.
FOLLOW SAFETY PRECAUTIONS OPERATORS MANUAL. SOME MACHINES MAY NOT BE
SUITABLE FOR USE WITH TRIMMER HEAD.
- Never forget that even though the F 202 M is an easy trimmer heads to use it may con-
stitute a danger if used improperly.
- For your personal safety always wear goggles or a face shield, adherent clothing, glo-
ves and shafety shoes as well as using a stone guard. (Fig. 10)
- Whilst working make sure no one is within 15 m by 360° radius. (Fig. 11)
- NEVER USE METALLIC LINE, ONLY NYLON LINE.
- Always use good quality line. Don't forget that poor quality line tends to weld together
causing interruption and inconvenience and prevents the head from performing as it
should.
ARNETOLI MOTOR S.R.L. - Via Ponte all'olivo - 50066 Reggello (FI) ITALY Tel. +39. 055. 863484 - Fax. +39. 055. 863485 - e-mail: [email protected] - www.arnetolimotor.it
2. Take off the outer reel
5. Overturn the spool and wind up in the direction
as indicated by the arrows on the side
8. Re-insert the outer reel on the
housing
3. Insert the lines in the inner
retainer holes
6. The lines must be wound up parallel with each
other and must not cross over each other
YES
NO
9. Once the line is in place, pull the lines
outwards to release them from the slits
Fig. 10
Fig. 11