ABBERFIELD NPD600 Інструкція з монтажу та експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з монтажу та експлуатації для Торгові автомати ABBERFIELD NPD600. ABBERFIELD NPD600 11 сторінок.

ABBERFIELD PACKET DISPENSING MACHINE - model NPD600 OPERATIONS MANUAL # 059-1

Installation continued....

FITTING DISPLAYS

Above the controller is a panel window that can be fitted depicting the

product being vended.

Undo the four screws inside the cabinet front door, corresponding to the four

outside corners of the fascia moulding. This leaves the fascia and control

electronics held in place by the centrally positioned M4 nuts.

Held in this way it is possible to gently bend the top section of the fascia

forward, just enough to slide the panel into place. It is recommended that the

backing card or label is held at the edges with sticky tape. This ensures that

it will not move once installed. Then replace the four corner screws.

This advertising frame bolts to the cabinet back plate and the cover fits over

the point of attachment.

1. Bolt the ground plate to the floor securely.

2. Fit over the Pedestal casting and column.

3. Securely bolt down the ground plate tie bolt.

4. Using a template, drill the base of the cabinet to accommodate mounting

bolts for the plinth.

5. Use the bolts supplied to secure the cabinet as if bench mounting.

Note: It is possible to run the mains cables down the pedestal and exit at

floor level, through a cut out in the rear of the pedestal. In this

application it is necessary to earth the cabinet and the pedestal stand

by cutting and terminating mains cable inside the cabinet.

32 Cross St, Brookvale, Sydney NSW 2100, Australia Tel: (02) 99392844 Fax: (02) 99383462 Email: [email protected]

page 8