ARNOLD 60455 Посібник - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник для Контролер ARNOLD 60455. ARNOLD 60455 20 сторінок. Mirrorball motorcontroller
Друкувати сторінкуMirrorball Motorcontroller
IMPORTANT:
The manufacturer will not accept liability for any resulting damages caused by the non-observance of
this manual or any unauthorized modification to the device.
●
Never let the power cord come into contact with other cables! Handle the power cord and all
connections with the mains with particular caution!
●
Never remove warning or informative labels from the device. Do not open the device and do not
modify the device.
●
Never use anything to cover the ground contact.
●
Never leave any cables lying around.
●
Never use the device during thunderstorms, unplug the device immediately.
●
Do not connect this device to a dimmer pack.
●
Do not switch the device on and off in short intervals, as this would reduce the device's life.
●
Do not shake the device. Avoid brute force when installing or operating the device.
●
Only use device indoors, avoid contact with water or other liquids.
●
Only operate the device after having checked if the housing is firmly closed and all screws are
tightly fastened.
●
Only operate the device after having familiarized with its functions. Avoid flames and do not put
close to flammable liquids or gases.
●
Always hold the fixture by the transport handle.
●
Always allow a free air space of at least 50 cm around the device for ventilation.
●
Make sure that the device is not exposed to extreme heat, moisture or dust. Make sure that the
available voltage is not higher than stated on the rear panel.
●
Make sure that the power cord is never crimped or damaged. Check the device and the power
cord from time to time.
●
Make sure that the rotation of the mirror ball is not interrupted in any way by decoration parts, etc.
●
Make sure that the mirror ball cannot start swinging due to air streams, etc. The mirror ball and the
motor should be hanged and operated absolutely vibration-free.
●
Regularly examine whether the keyring and the chain have any deformations. If they do,
immediately detach the mirror ball.
●
The length of the chain (with the mirror ball) may never exceed 100 cm.
●
If the external cable is damaged, it has to be replaced by a qualified technician.
●
If device was dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
●
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do
not switch it on immediately. The arising condensation water might damage your device. Leave
the device switched off until it has reached room temperature.
●
If your Arnold Lichttechnik device fails to work properly, discontinue use immediately. Pack the
device securely (preferably in the original packing material), and return it to your Arnold
Lichttechnik dealer for service.
●
For adult use only. The Mirrorball Motorcontroller must be installed out of the reach of children.
Never leave the device running unattended.
●
Never attempt to bypass the thermostatic switch or fuses.
●
The user is responsible for correct positioning and operating of the Mirrorball Motorcontroller. The
manufacturer will not accept liability for damages caused by the misuse or incorrect installation of
this mirror ball control system.
●
This device falls under IEC protection class III. This device shall be connected to an external power
supply.
●
Before connecting the device to the external power supply, make sure that the current, voltage and
frequency match the input voltage, current and frequency specified on the information label on the
device.
●
Repairs, servicing and electric connection must be carried out by a qualified technician.
●
WARRANTY: Till one year after date of purchase.
Ordercode: 60455
3