Blair Digital Chanter Посібник користувача - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник користувача для Музичний інструмент Blair Digital Chanter. Blair Digital Chanter 14 сторінок.

Calibrating the sensors (continued)

To best learn how the sensors are adjusted set the value of Sensor Hole HA to '-50' and notice the High A ﬁnger doesn't

need to cover the hole for the High G note to sound. 

Alternatively, set the Sensor Hole HA to '+ 80' and notice that even with the the High A ﬁnger covering the hole, it

doesn't sound the High G note. This tells us the sensor is too sensitive to detect our ﬁngers. 

Here's the general process to set each Sensor which is quick, easy, and once set, requires only minimal 'tweaking'. 

** Please note our skin changes as does the ability to consistently lift the ﬁnger the same height, therefore if a sensor is

set too sensitive and our playing has changed, then adjustment will be needed.  

Start with the High A hole. Navigate to the Sensor menu, select Hole HA.  

Place your thumb on the hole and play a High A grace note. Adjust the Hole HA sensor value until both the High A and

High G can be heard. Once satisﬁed, press switch (Enter) and navigate to Hole HG.  

Repeat the process for each note hole, keeping in mind how you would normally lift your ﬁngers while playing.

• Advanced settings

The Advanced settings menu allow further customisation of overall settings.

To enter the Advanced menu, go > Main menu, then scroll to Advanced and press Enter.

The following menu items are available in Advanced. 

Menu for adjusting the individual sensors. Refer to How to navigate to the Sensor menu.  

The ALR controls the amount of high level sunlight and extreme temperature that may affect the Chanter when

playing outdoors. If the sunlight is high, ﬁnger sensors maybe triggered and notes sounded without actually

playing. The regulator has four levels of control; Low, Med, High & Extreme.

Unless outside in direct sunlight this should always be set to OFF. If activated step up the ALR from low to

extreme until the ambient light is restricted from interfering with the sensors. For playing indoors, the ALR

should be set to OFF. 

Dsp Int: Display Intensity, this controls the brightness level of the OLED screen. 

Dsp T/O: Display time-out speciﬁes the time for when the screen turns OFF, however the Chanter remains on

and functioning. This can be used to save battery power, or when performing. 'Enter' can be pressed to activate

the display if it has timed-out. 

Pwr T/O sets the time for when the unit is not being played to shutdown. This is commonly referred to as a

power-save function. The settings are 2min, 5min, 10min and Off. 

Updater Select when connecting to a PC and installing software updates. Also when determining which

ﬁrmware version the chanter has installed. 

>Advanced

Shutdown

>ALR

Dsp Int

<Off>  