3D Hobby Shop 57" Extra 330 SC Посібник з монтажу - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник з монтажу для Іграшка 3D Hobby Shop 57" Extra 330 SC. 3D Hobby Shop 57" Extra 330 SC 16 сторінок.

Install elevator servo with servo output spline toward front of plane and install arm and tighten pushrod

connector.

The rudder pull-pull cables are assembled as shown in the above diagram.

Assemble the pull-pull wires onto the rudder horn as shown, double-looping the wire through the brass

crimp sleeve before crimping. Crimp the brass crimp sleeve tightly with pliers and apply a drop of thin CA

to the crimp. Be SURE to use medium or thick CA to lock the 2mm nuts on the rudder control horn. Feed

the wires into the fuselage slots and forward to the front of the fuselage. Cross the wires once so they

make an X inside the fuselage.