3D Hobby Shop Edge 540 Посібник з монтажу - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з монтажу для Іграшка 3D Hobby Shop Edge 540. 3D Hobby Shop Edge 540 17 сторінок.

Друкувати сторінку
6
Your model uses pull-pull cables to actuate the rudder. Please examine the pull-pull system assembly
diagram closely:
Start the pull-pull installation by screwing the ball links onto the pull wire ends 5 to 6 threads. The cables
are already run through the fuselage for you. After you crimp the crimp sleeves onto the wire, place a
small drop of thin CA glue on the crimped joint. Assemble both the right and left cable ends in the rear of
the plane as shown.
Fit the rudder onto the fuselage and glue the hinges using 2 large drops of thin CA glue per hinge.