ARO 7149-C Посібник оператора - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник оператора для М'ясорубка ARO 7149-C. ARO 7149-C 12 сторінок. “22” series short grinders

DISASSEMBLY

AND ASSEMBLY

OF TOOLS

Disconnect air supply from tool or shut off air supply and exhaust

(drain) line of compressed air BEFORE performing maintenance

or service to tool.

Before starting to disassemble or assemble this tool (any part or

completely), be sure to read "Inspection, Maintenance and lnstal-

lation" section.

To minimize the possibility of parts damage and for convenience,

the steps for disassembly or assembly listed on the following

pages are recommended.

The basic sections and instructions for removing them from the

tool are as follows:

MOTOR SECTION

Remove collet nut (41751) and collet insert (41750-). Using a

5/32" hex type wrench, insert hex wrench thru collet body and into

hex end of rotor to hold rotor from turning and remove collet body

(41752).

Locating on flats of head, secure head in a suitable holding de-

vice. Using a strap type wrench on motor housing, unthread and

remove motor housing from head. Remove motor assembly from

housing. For complete disassembly of motor, see page 7.

HEAD SECTION

Throttle components can be serviced without removing head sec-

tion from tool. See page 8 for complete disassembly.

To remove screen (44933) from housing, remove retainer ring

(35619) and exhaust sleeve (43833-l).

TYPICAL CROSS SECTION OF TOOL