ARO GV08A-03S-7 Посібник оператора

Переглянути онлайн або завантажити pdf Посібник оператора для Електроінструмент ARO GV08A-03S-7. ARO GV08A-03S-7 12 сторінок. Sanders/polishers

Друкувати сторінку

SECTION

MANUAL

Ml0

174

Tool & Hoist Products

INCLUDING: OPERATION, INSTALLATION & MAlNTENANCE

Released:

4-30-94

Revised:

4-30-94

MODELS GV08A-03S-7,

GV08A-05S-7,

and GV08A-06S-7

SANDERS

MODEL GV08A-02P-7

POLISHER

IMPORTANT

SAFETY INFORMATION

ENCLOSED.

READ THIS MANUAL

BEFORE OPERATING

TOOL.

FAILURE TO OBSERVE

THE FOLLOWING

WARNINGS

COULD RESULT IN INJURY.

Always operate, inspect and maintain this tool in

accordance with American National Standards

Institute Safety Code for Portable Air Tools

(ANSI Bl86.1).

For safety, top performance, and maximum

durability of parts, operate this tool at 90 psig

(6.2 bar/620 kPa) maximum air pressure at the

inlet with 3/8" (10 mm) inside diameter air supply

hose.

Air powered tools can vibrate in use. Vibration,

repetitive motions or uncomfortable positions may

be harmful to your hands and arms. Stop using

any tool if discomfort, tingling feeling or pain

occurs. Seek medical advice before resuming use.

Always turn off the air supply and disconnect the

air supply hose before installing, removing or

adjusting any accessory on this tool, or before

performing any maintenance on this tool.

Keep hands, loose clothing and long hair away

from rotating end of tool.

Anticipate and be alert for sudden changes in

motion during start up and operation of any power

tool.

Check for excessive speed and vibration before

operating.

Tool accessory may continue to rotate briefly after

throttle is released.

Do not lubricate tools with flammable or volatile

liquids such as kerosene, diesel or jet fuel.

Do not remove any labels. Replace any damaged

label.

Use accessories recommended by ARO Tool.

The use of other than genuine ARO Tool replacement parts may result in safety hazards, decreased tool performance,

and increased maintenance, and may invalidate all warranties.

ARO Tool is not responsible for customer modification of tools for applications on which ARO Tool was not consulted.

Repairs should be made only by authorized trained personnel. Consult your nearest ARO Tool Authorized Servicenter.

It is the responsibility of the employer to place the information in this manual into the hands of the

operator.

For parts and service information,

contact your local ARO distributor, or the Customer Service Dept. of the Ingersoll-Rand

Distribution

Center,

White House, TN at PH: (615) 672-0321,

FAX: (615) 672-0601

ARO Tool & Hoist Products

Ingersoll-Rand Company

Company 1994

Printed in U.S.A.

Part of worldwide

Ingersoll-Rand