AROFLY X-ELITE Посібник із швидкого старту - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Аксесуари для велосипедів AROFLY X-ELITE. AROFLY X-ELITE 10 сторінок.
INSTALLING AROFLY SENSOR ON CYCLE REAR VALVE ONLY
Tips:
Before installing AROFLY sensor to the rear tire valve, please inflate the bike
tires to appropriate tire pressure as marked on the tire. Suggest the road
bike to be 90~120psi (6~8bar); Mountain bike to be 35~65psi (2.4~4.5bar)
Before using AROFLY sensor, twist open the cap, then remove the INSULATION
TAB, from between the battery contact.
Place Wrench onto the AROFLY Base.
Twist counter-clockwise to open
AROFLY Cap.
Installing AROFLY to the cycle rear valve: If it is a Schrader valve, please install
directly; If it is a Presta valve, please use the Presta valve adaptor first, included
in the kit, before installing the AROFLY sensor.
If it is a Presta valve, please loosen
"the valve pin" to the top-end of the
Presta valve shaft.
Twist Adaptor firmly on the Presta
valve.
If it is a Schrader valve, AROFLY can
be installed directly onto the rear
valve (no need for any adaptor).
Pull and remove Insulation Tab from
AROFLY to connect battery. Replace
the cap to AROFLY.
Install "Valve Adaptor" on Presta
valve.
E n su re th e c o rre c t si de of t h e
Adaptor to the Valve.
Install AROFLY on the Adaptor.
Be sure to twist tightly to avoid
air leakage, and to ensure good
contact with valve pin.
Insulation Tab