ACOUSENCE dac-pre MKII Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач ACOUSENCE dac-pre MKII. ACOUSENCE dac-pre MKII 17 сторінок. Da converter / preamplifier
Indicator of the sample rate at the input
The sample rate indicator shows the frequency of the selected digital input. 44.1kHz
is at the bottom, 192kHz is at the top. The other four common sample rates (48kHz,
88.2kHz, 96kHz, 176.4kHz) are in between. If no valid digital signal is present, no LED is
lit.
Note the following special feature:
If a valid digital signal is applied or selected via input selection, or if the sampling rate
is changed, the audio signal is always switched directly. However, the device runs for
a few seconds on a kind of "auxiliary PLL" with a reduced quality compared to the main
PLL. During this time, the high-precision clock recovery, the "arfi-femto-reclocking",
first detects the sampling rate and then adjusts the operating parameters
accordingly. Then the clock source is switched automatically. Only when an LED lights
up for one of the six possible sample rates, the "arfi-femto-reclocking" is active. (In
fact, switching from the "auxiliary PLL" to "arfi-femto-reclocking" usually happens
even a close second before the LED lights up).
Phono module (optional)
If the optionally available phono module is equipped, the ANALOG IN inputs is
connected to it. If RCA inputs are also equipped, there is a toggle switch on the rear
panel for switching between RCA and XLR. Here, in principle - in contrast to all other
RCA connections - both connections could also be assigned in parallel and the
respective source could be selected via the switch. As a rule, however, this should be
a basic setting that is made once to match the existing turntable. Therefore, the
switch is located at the back near the connection sockets. Switch pointing
downwards towards RCA selects RCA; pointing upwards towards XLR selects XLR.
The module is - as indicated at the time of ordering - permanently equipped for MM
or MC. However, a later change is quite uncomplicated by exchanging the two input
assemblies. Please talk to your dealer.
9