CubuSynth Dual CS-20 VCF Посібник зі збірки - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник зі збірки для Синтезатор CubuSynth Dual CS-20 VCF. CubuSynth Dual CS-20 VCF 16 сторінок. Dual / stereo multimode vcf with self-oscillating resonance and intuitive routing and cv modulation matrix
Також для CubuSynth Dual CS-20 VCF: Посібник (9 сторінок)

Друкувати сторінку

CubuSynth Dual CS-20 VCF - Build Guide

STEP 17 (control PCB)

Controls

B100K Pot

B100K Tall Trimmer

PJ-301M

First, place fix the M3 spacer, like shown in the picture.

Now take the Potentiometers and jacks and put them in

place as marked on the PCB but don't solder yet.

In the picture below you can see the placement.

When everything is in place, take the front panel and

put it on top, so all controls go into each corresponding hole of the panel. "wiggle" the front

panel into place and make sure everything fits well.

Fit all nuts to the Potentiometers and the Jacks.

Be careful when turning the board around, so that all the components stay in place.

Then solder everything.

Page 13

CUTOFF,LP-HP-1,LP-HP-2,RESO

CV1A,CV2A,RCV1A,RCV2A,

CV1,CV2,IN1,IN2,OUT1,OUT2,RCV1,RCV2,V/O1

PCB V1.4 Mar 2023