Dish Network DISH 1000 Інструкція з монтажу Посібник з монтажу - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Антена Dish Network DISH 1000. Dish Network DISH 1000 16 сторінок.
Також для Dish Network DISH 1000: Посібник (18 сторінок), Посібник (20 сторінок)
Друкувати сторінку
From the
Point Dish
should see an
Installation Summary
screen shows reception from the 119°W and 110°W satellites on all available satellite tuners. Also
confirm the LNBF is correctly identified as a
models may identify this LNBF as a
Exit the
Installation Summary
signal strength bar is green and locked for the 119°W and 110°W satellites.
: If the signal strength bar is not green and locked, toggle the transponder number up one and
Note
then back down one.
Exit the
Point Dish/Signal
receiver software upgrade. If exiting the
described in the receiver user's guide, then turn off the receiver for at least 20 minutes (on most
receivers) to allow the receiver to take a software upgrade.
Run
Check Switch
110°W satellites.
If installing an additional receiver:
•
DISH Pro Plus - Connect the receiver and repeat steps 9 through 14 of this procedure.
•
DISH Pro or Legacy - Connect the receiver. Turn the receiver off to take a software download
(takes about 20 minutes on most receivers). Run
shows reception from the 110°W, 119°W, and 129°W satellites. Note, on Legacy receivers, the
DP Plus Twin will be identified as SW64. This indication is OK and does not indicate a problem.
Page 6
screen, run
Check Switch
screen similar to the one shown below. Make sure the summary
DP Twin
screen and display the
screen and follow your receiver user's guide instructions for taking a
Point Dish
again and confirm reception for 129°W, as well as reception for the 119°W and
.When the
Check Switch
(some early factory software on some
DPP Twin
. This identification is OK).
: If you have current
Note
software, you might see
under
on the Installation
Port 3
Summary screen.
Point Dish/Signal
screen does not start the upgrade process as
Check Switch
procedure finishes, you
129°W
screen. Make sure the
. Make sure the summary screen