Aroma360 VanGogh360 Інструкція - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція для Аксесуари Aroma360 VanGogh360. Aroma360 VanGogh360 4 сторінки.
Також для Aroma360 VanGogh360: Інструкція (4 сторінок), Посібник із швидкого старту (2 сторінок), Посібник з усунення несправностей (2 сторінок)

Друкувати сторінку

The Vangogh360 is a flexible unit that has stand-alone capabilities and HVAC capabilities. Here are the

instructions for getting your Vangogh360 to work with the HVAC system.

1. Remove the silver nozzle at the top of the unit by unscrewing it counterclockwise.

2. Replace it with the External HVAC Connector Nozzle (black part facing up) and screw it in clockwise and

make sure it is tightly secured.

3. Using a screwdriver, make a scent point (a small hole) in the duct work that is between 0.5-1.5 feet after

the air handler. The diameter of the scent point should be the same as the clear tube that was included

with your Vangogh360.

4. Insert one end of the clear tube into the External HVAC Connector Nozzle and the other end into the

duct work. Be sure to cut any excess tubing. Seal the scent point with HVAC tape.

5. Make sure the silver button on the top side of the unit is out (so that the fan is switched off).

6. Attach the power adapter into the unit and plug into a 110v outlet. Program the Vangogh360 to the

desired settings and you're ready to start scenting!

7. Change the fan setting on your thermostat to "Always On".

Problem

No LCD

Power is not getting to the unit or the unit is

Indication

turned off.

Make sure the unit is plugged in.

Mist/Scent

Check the LCD display. If it says "OFF", the

unit is not set to be working at that time. If the

unit says "PAUSE" it's on the pause portion of

the interval.

Oil could be out.

Low

The nozzle may be clogged.

Mist/Scent

Oil Leakage

Ensure the Vangogh360 is a full upright

position.

Buttons are

The unit's settings may be locked.

not working

HVAC Connection

Troubleshooting

Reason

Solution

Plug in the unit and press the silver button that is on

the lower side part of the Vangogh360.

Ensure the power is connected and adjust the

working period times and days so that the unit is set

to "ON". Also, check the oil canister to make sure

there is oil in the bottle.

Run with rubbing alcohol for 3 minutes or change the

nozzle.

Remove the fragrance bottle and reattach making

sure it is screwed in straightly and is very tight.

Hold down the "SET" button for 10 seconds until you

hear a beep. The sound will indicate "lock mode" has

been disabled.