Aromachef Pizza Presto Інструкція з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Кухонна техніка Aromachef Pizza Presto. Aromachef Pizza Presto 6 сторінок. Portable gas oven

Друкувати сторінку

GAS CONNECTION

Type I: Low pressure regulator with flexible hose

• Before you assemble the regulator, please check the gas type and

pressure shown on the gas cylinder, and make sure the

information on the regulator and cylinder corresponds.

• The hose connecting the appliance and gas cylinder is required,

and the max length should not exceed 1.5m.

• Do not twist or kink the flexible hose after use, turn the

gas cylinder valve off, wait for the flame to go out, then turn the

appliance control valve(s) off.

NOTICE:

• Only use the hose assembly as supplied with this appliance for

connection to the cylinder - DO NOT USE ADAPTORS.

ASSEMBLY:

1. There is one 5/8-18UNF thread that located at the rear body of the

pizza oven for gas connection.

2. Connect the female thread of the regulator to

gas inlet of pizza oven. Tighten connection by

turning the female connector clockwise

2. Connect the male thread of the regulator to

gas cylinder. Tighten connection by turning the

male connector counter clockwise.

WARNING: Close both gas cylinder and pizza oven valve before

connecting them by the regulator.

DISASSEMBLING THE REGULATOR

Disassemble both ends of regulator from gas cylinder and pizza oven

as reverse operation of assembly.

LIGHTING OVEN INSTRUCTIONS:

Do not lean over the oven while lighting.

1. Remove all appliances from the oven to create a free flow of air.

2. Keep the oven door cover open. Do not attempt to light the oven

with the cover closed.

3. Push the button and turn it anti-clockwise. The piezo ignition will

light the burner directly.

NOTE: Try the above process several times until you light the burner.

If you can't light it first time there may be some air in the

burner and gas tube.

4. You can view the flame to make sure the

burner is lighted.

5. Adjust the controls to the desired position.

Notice: If the flame is accidentally extinguished, turn the knob to

OFF and wait a few minutes before attempting to ignite.

BURNER FLAME CHECK

Light the burner and rotate knob from HIGH to LOW. You should see a

smaller flame in LOW position than on HIGH.

Close position

High position

Low position

Always check flame prior to each use. A good flame should be blue

with minimal yellow tip. Some yellow tips on flames are acceptable

as long as no carbon or soot deposits appear.

WARNING

Take care that the openings at side and rear of the appliance are

not obstructed, or that air flow is not restricted by placing items

or other appliances close to, or adjacent to openings. Do not build

this appliance into a cavity or enclosure.