3D Robotics IRIS Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для Дрони 3D Robotics IRIS. 3D Robotics IRIS 5 сторінок. Tarot gimbal

4 Power

Connect the gimbal power cable with the red, JST connector to the matching cable

protruding from the bottom of IRIS. If you do not see the cable, please see the advanced

gimbal instructions at

5 Attach the gimbal to IRIS

Use the two mounting screws to attach the gimbal to IRIS using the two holes

in the interface plate and the two holes in the bottom shell shown below.

Operating the gimbal

Start your flight by following the preflight steps described in the IRIS Operation

Manual and Flight Checklist.

Upon powering IRIS, the gimbal will display a solid yellow light while it is starting

and calibrating. Do not touch the gimbal while it is starting up. When the gimbal

displays a blinking blue light, it is ready to fly.

If the gimbal is not connected to the autopilot, it will perform automatic

stabilization without enabled transmitter control, indicated by a solid blue light.

Calibrating, do not touch gimbal

Ready, connected to autopilot

Ready, not connected to autopilot

3dr.com/iris/info.

Mount the gimbal with the

camera facing forward.