ARP Fridge Defend Інструкція користувача - Сторінка 15

Переглянути онлайн або завантажити pdf Інструкція користувача для Автомобільні аксесуари ARP Fridge Defend. ARP Fridge Defend 17 сторінок. V5 + fan control
Також для ARP Fridge Defend: Посібник користувача (10 сторінок)

Друкувати сторінку

ARP Control v5.x

ARP BUTTON

Press SetUp Button to

store settings. Keep an

eye on the display, StO

will flash, once StO

flashes the button may

be released.

Momentary press Display Button to

advance to next variable

Press SetUp Button to

toggle through all

recorded error

messages.

Momentary press Display Button to

roll around to the first variable AtO

ERRORS and/or MISTAKES DURING SetUp SESSION

Mistake During SetUp Session?

Do you think a mistake was made during the SetUp session?

Just turn off the control as described above without performing a save procedure (S--).

ARP DISPLAY

Example: If during the startup tests, or the periodic tests an IEC error

is registered, the error will be recorded here. By using the SetUp

button, each error that has been recorded will be displayed in a

sequence. Write down the error that has been displayed for any

communications with technical support.

See Troubleshooting Guide for list of errors and their meaning.

FURTHER INFORMATION

WARNING

All setting changes must be

stored before they will take

affect. If one exits the SetUp

without storing, the settings will

remain the same as they were

before SetUp was used.

When StO is seen, the settings have

been saved to the control memory.

The control can be turned off anytime

while in SetUp, see Turn OFF ARP

Control in All Modes.

This variable stores the errors that

have occurred during the life of the

ARP operation. These values cannot

be cleared.

If there are no recorded errors,

be displayed. The next press of the

SetUp button will return the display to

the

Er0

variable name. Otherwise, if

errors are recorded, use SetUp button

to toggle through all errors recorded.

It is always a good idea after making

changes to go through the variables

again to check the new settings.

No problem!

will