3D Systems CubeX Trio Заміна друкуючої стрічки - Сторінка 5

Переглянути онлайн або завантажити pdf Заміна друкуючої стрічки для 3D-принтери 3D Systems CubeX Trio. 3D Systems CubeX Trio 7 сторінок.

Друкувати сторінку
3
Put the CubeX printer into manual move mode.
4
Raise the print pad until it is approximately 5mm away from the print tips.
5
Slowly raise the print pad until it lifts the new print tip in line with the others. All three print tips should be
touching the bed without putting any pressure on it.
6
Turn the CubeX printer off and unplug it from the mains power supply.
7
Using the 2.5mm hex driver, tighten the print tip holding bolt (pictured) to lock the print tip in place.