displayit flare Інструкція з монтажу

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Цифрові вивіски displayit flare. displayit flare 4 сторінки. Accessory kiosk with monitor mount
Також для displayit flare: Інструкція з монтажу (3 сторінок)

Друкувати сторінку
CAUTION:
METAL EDGES
MAY BE SHARP
2. Assemble top and bottom of
frame using "I" shaped
straight
connectors. Hand tighten wing
nuts to secure.
46" SM
46" SM
46" SM-PWR
Power Transformer
Wire Pass-through Grommet
Foot Holes
46" SM-FT-AC
Unlock
Unlock
Click
Click
5. Attach bottom half of support poles to bottom frame piece.
To attach support pole, pull the latch lever to unlock clasp.
Firmly push clasp into center channel of frame. Close latch
lever to secure. The frame should look like Diagram 2.
Note: Lever may not close all the way.
displayit.com
1. Lay out frame pieces as seen in Diagram 1. Frame perimeter pieces are labeled with stickers
matching Diagram 1 to make this step easier. We recommend assembling the frame on its back.
3. Assemble sides using "H"
shaped
straight connectors.
Hand tighten wing nuts to secure.
46" SM
Diagram 1
46" SM
Support Pole with
Push-Button Connector
46" SM
Foot Holes
46" SM-FT
Lock
Lock
displayit.com
800.207.0311
800.207.0311
Assembly Instructions Page 1
Vertical
Vertical
Horizontal
Horizontal
4. Assemble perimeter of frame.
using
corner
connectors.
Do not tighten down wing nuts
until support poles are secure.
Approximately 39" Apart
(Room for one short and one long light bar)
Middle Channel
Middle Channel
for Double-Sided
for Double-Sided
Back Channel
Back Channel
for Single-Sided
for Single-Sided
6. For single-sided displays, install the
support pole into the back channel of
the frame.
Note: For double-sided displays, make
sure to leave space for the light bars as
seen in Diagram 4 on the following page.
After-Hours Emergency: Call or Text 678.723.5343
After-Hours Emergency: Call or Text 678.723.5343
8' (92" x 92") Flare
Need Help?
Scan the QR code or go to
displayit.com/flare-guide
to watch an assembly video.
Gap for
Gap for
Lights
Lights
Diagram 2
Bottom Half
of Support Pole
7. Attach top portion of support
poles support poles with
push-button connectors.
Lock upper latches to the top of
the frame.
Flare v1.8 Updated 3/1/2016