Displays2go WXNTVGBO1 Інструкція з монтажу
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Стелажі та підставки Displays2go WXNTVGBO1. Displays2go WXNTVGBO1 2 сторінки. Tv stand with glass shelf
Друкувати сторінку
WXNTVGBO1 - TV STAND WITH GLASS SHELF
PLEASE READ THESE INSTRUCTIONS COMPLETELY AND MAKE SURE YOU ARE COMFORTABLE
WITH THE INSTALLATION PROCESS. ALSO CHECK YOUR TV'S USER MANUAL TO SEE IF THERE ARE
ANY SPECIAL REQUIREMENTS FOR MOUNTING YOUR TV.
WARNING:
1. Max Weight: 110 lbs. It is the installer's responsibility to make sure that the weight of the display monitor
does not exceed 110 lbs.
2. Use this TV stand only for its intended use as described in these instructions. Displays2go is not responsi-
ble for damage or injury caused by incorrect assembly or use.
3. A remote control or toys placed on the glass shelf may encourage children to climb onto the TV stand and
as a result the TV stand may tip over and fall onto the children. Serious injury or death may occur.
Two people are recommended to assemble the product.
If you do not understand these instructions or have questions about the safety of the installation, assembly or
use of this product, please contact DISPLAYS2GO Customer Service at 1-800-572-2194.
COMPONENT AND HARDWARE
A. Screw M8X33mm
B. Washer_L ID=8.4mm
C. Hex Key M6
D. End Plate
E. Pointed Foot
F. Bracket_shelf
G. Bracket_1_shelf
H. Bracket_2_shelf
I. Extrusion
J. Hex Key M4
K. Slide-in T-nut
L. Screw M8X16mm
1. Install (6) pointed feet (E) into the
base (U) from the bottom.
M. Hex Key M5
X4
N. Washer_S ID=8.4mm
X4
O. Square Plate
X1
P. TV Plate
X2
Q. Cup Nut
X6
R. Rubber Washer
X1
S. Screw M8X14mm
X1
T. Adapter Bracket
X1
T1. Adapter Bracket
X1
U. Base
X1
V. Glass Shelf
X1
X6
2. Align tapped holes in the extrustion (I) with pre-drilled holes in the
base (U), with an end plate (D) in between these 2 parts. Secure the
extrusion by using (4) screws (A), (4) washers (B) and (4) rubber wash-
ers (R). See part numbers shown below. A second person may be
required to help with the assembly.
I
Rx4 Bx4 Ax4
Dx1
C
X1
X8
X1
X1
X4
X8
X4
X1
X1
X1
X1
1 of 2