Acoustic Energy Aegis Neo One Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Спікери Acoustic Energy Aegis Neo One. Acoustic Energy Aegis Neo One 8 сторінок. Aegis neo series
Друкувати сторінку
9. Amplifiers
The Aegis Neos are relatively high sensitivity speakers that do not require
generously rated power amplifiers for adequate volume levels to be achieved in an
average listening room. A minimum of 25 and maximum of 120 Watts into 8 Ohms
per channel is recommended. Aegis Neos also offer a relatively easy load to the
amplifier and do not make unusually heavy demands on its power delivery.
No overload protection systems are fitted to the Aegis Neos so it is possible to
cause damage through over-driving. Such damage can occur whatever the power
rating of the amplifier and is not covered by any warranty. If ever the sound at
high volumes becomes distorted your speakers are at risk of damage. In such
circumstances the volume must be reduced.
11. Specifications
Model:
Aegis Neo One
Type:
2-way, reflex loaded.
LF Driver
N/A
LF/MF Driver:
130mm pressed alloy cone.
LF & LF/MF Magnet Systems
Neodymium.
HF Driver:
25mm Neodymium Ring Radiator.
Filter Network:
3rd order at 3.5kHz.
Cabinet:
Braced 15mm MDF carcass.
Frequency Response:
60Hz to 40kHz ±3dB
Frequency Range:
45Hz to 45kHz @ -6dB
Power Handling:
120W peak programme
Amplifier Compatibility:
25 - 120 Watts into 8 Ohms
Nominal Impedance:
8 Ohms
Sensitivity:
89dB for 1 Watt at 1 metre
Dimensions (H x W x D):
357 x 182 x 237mm
Weight:
6 kg (single, unpacked)
Acoustic Energy reserves the right to modify product specifications.
Page
Page
10. Listening
It is wise before listening to your speakers to make
one final check of the cables and connections. If all
appears well begin listening at a relatively low level
to confirm that the system is operating as expected.
Only increase the volume if you are happy that the
sound at low levels is fundamentally as expected. If you
are unhappy, turn the system off and re-check all the
cables and connections.
Aegis Neos may take a little time to "run-in", and
similarly the system will also perhaps take some
time to reach normal operating temperatures. It is
unwise therefore to make rapid judgements about the
performance of the speakers. Your ears too will take
some time to adjust to the new sound, so revisiting the
system set-up, speaker positioning especially, is best
left for a few days.
Aegis Neo Three
2.5-way, reflex loaded.
130mm pressed alloy cone.
130mm pressed alloy cone.
Neodymium.
25mm Neodymium Ring Radiator.
1st order at 200Hz
3rd order at 3.5kHz.
Braced 15mm MDF carcass.
43Hz to 40kHz ±3dB
35Hz to 45kHz @ -6dB
170W peak programme
25 - 170 Watts into 8 Ohms
8 Ohms
90dB for 1 Watt at 1 metre
905 x 203 x 242mm
14 kg (single, unpacked)
Aegis Neo Centre
2.5-way, sealed enclosure.
130mm pressed alloy cone.
130mm pressed alloy cone.
Neodymium.
25mm Neodymium Ring Radiator.
1st order at 200Hz
3rd order at 3.5kHz.
Braced 15mm MDF carcass.
75Hz to 40kHz ±3dB
63Hz to 45kHz @ -6dB
120W peak programme
25 - 150 Watts into 8 Ohms
8 Ohms
90dB for 1 Watt at 1 metre
178 x 480 x 195mm
9 kg (single, unpacked)