CAMDEN CM-300 Інструкція з монтажу
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Система відкривання дверей CAMDEN CM-300. CAMDEN CM-300 2 сторінки. Exit switch & integrated timer
Також для CAMDEN CM-300: Інструкція з монтажу (2 сторінок)
Друкувати сторінкуD o o r Ac t iv ati o n D e v i c e s
CM-310EE
Exit Switch & Integrated Timer (Ver. 2)
INSTALLATION INSTRUCTIONS
1. GENERAL DESCRIPTION
Camden model CM-310EE is an illuminated
Exit switch incorporating a 30 second timer.
The stainless steel faceplate is designed to flush
mount on to a 1 ¾" wide doorjamb.
The ½" x ¾" rectangular translucent button is easy
to push. CM-310EE model is supplied with a LED
light bulb, which is accessed through the front
of the switch. If the unit is powered 24VDC, the
supplied in-line resistors must not be removed.
2. SPECIFICATIONS
Models
Operating Voltage
Time Delay
Contact Rating
Incandescent
Bulb Life
Mounting
Lens Colour
Legend
Dimension
3. INSTALLATION
Mounting
The unit is completely pre-wired for easy installation. Connect
the appropriate wires to your devices as per the enclosed wiring
diagram. Tuck wiring into box (retrofit box included), and fasten
switch plate using screws provided.
This switch has been designed specifically to
release a magnetic lock from the inside, as per
the BOCA code. When the button is pushed and
released, the lock will release for 30 seconds.
Re-trigger is possible at any time.
The "double break" circuitry has been designed so
that even if the timer fails, depressing the switch
will interrupt power to the magnetic lock.
CM-300
12 or 24 V DC
30 seconds
4 amps @ 30 VDC
15,000hrs.@ rated capacity
2 x #6-32 machine screws
Green
'PUSH TO EXIT'
2.75" W x 4.5" H x 1 5/16"
(70mm x 114mm x 33mm)
Wiring
Six color coded leads are provided. This unit will operate on 12 or
24 VDC, with no jumper change required. For convenience it may
be powered by the same power that supplies the magnetic lock.
The two pairs of Red & Black wires connect to 12 or 24 VDC.
One pair supplies power to the timer, and the other pair powers
the light. The internal timer and the push button are connected
in series with the Green & White wires. This is how the "double
break" feature works. Therefore, the unit must be wired as
shown.
The Green wire goes to the positive input wire of the magnetic
lock, and the White wire goes to a source of + Voltage. Please
refer to the enclosed wiring diagram for typical hook-up.
Important:
CM-310EE models have connected lead wires with
black-colored heat shrink (over an in-line resistors).
If powered 24V; Do not remove in-line resistors.
If powered 12V; Cut (remove) in-line resistor on the
black lead.
4. LIMITED WARRANTY
Camden Door Controls Inc. warrants this product to be free
from defects for 3 years from date of manufacturing. Visit our
web site at www.camdencontrols.com to see our complete
warranty policy, including limitations and the procedures for
product returns.
CM-310EE
Page 1 of 2