3D Upfitters AnkerMake M5 Посібник з монтажу - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник з монтажу для Корпус 3D Upfitters AnkerMake M5. 3D Upfitters AnkerMake M5 18 сторінок.

5. Top Panel

Before attaching the top, now is an excellent time to insert the support beam. It is a

tad wider than the enclosure so that it doesn't fall out when moving the enclosure.

Next, use access through the front and side doors to attach the top of the enclosure

using M4 12mm screws. You'll also connect the top on the four corners to each mid-

panel connector. Note that if you purchased the model with the 6mm front and

3mm sides, there will be a front and back to the top! The front lip is slightly longer

to ﬁt over the 6mm front, so carefully check for ﬁtment and ﬂip over the top if

necessary.