3d-printz Naughty 2000 Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка 3d-printz Naughty 2000. 3d-printz Naughty 2000 9 сторінок.

Then glue the motor holder into Fusfront_front, and push the cockpit into

Fusfront_front as far as it will go and glue it - make sure that it is straight:

Now the fuselage servos can be installed. Later, they are harder to access! When

the servos are screwed in, slide the front fuselage section into the rear one

(Fusfront_rear) and glue – make sure it is straight again!

Put an M6 nut into the Fusfront_rear (where the wingscrew front comes in) - the nut

should be heated with a lighter to slide into the recess by the wing mount. After

that, Fusspar_rear can be glued in.

Finally glue the front fuselage part to the rear one. To do this, insert the 8mm

carbon tube into the rear fuselage, attach the skid as a test, push it into the front

fuselage section and shorten the 8mm carbon tube to the correct length (800mm

should fit). Then the tube can be glued to the rear part of the fuselage - you should

make sure that the tube reaches into the recess in the skid (but don't glue the skid